Articles

Installing Losi's 3-Shoe Clutch On Your TEN-T

Posted:  Thursday, December 29, 2011
Written By:  Gary Katzer
Copyright:© 2011 Horizon Hobby, Inc.

The Losi 810 and TEN-T vehicles offer a lot of performance straight from the box. This performance can be directly attributed to the excellent 3.4cc mill that comes bolted into the engine bay. While both the 810 and TEN-T do have strong out-of-box performance, it's possible to take it to the next level if you're looking for even better punch and acceleration. The new Losi 3-Shoe Clutch conversion replaces the stock composite 2-Shoe configuration with a more traditional 3-Shoe configuration. Losi's Ryan Dunford has been hard at work to make this conversion a reality and shows us the exact steps and procedures needed to install the conversion. From start to finish it should take you about 20-minutes, not including removing and reinstalling the engine on your chassis. Without any further delay, let's roll up our sleeves and get to work!



Tips & Tricks